|
How do I remove unwanted wallpaper?
Before installing the new wallpaper, it is always best to remove the old. Sand or score the wallpaper, and then wet a small area with remover. Rewet if necessary. Remove wet wallpaper with a scraper.
How do I prepare my walls for wallpapering?
Clean all walls before starting. Walls with rough surfaces should be sanded. When patching holes, do not use an oil-based product, as it can bleed through the wallpaper. If removing the old wallpaper will cause damage, it is best to use a primer/sealer before installing the new wallpaper, as well as a vinyl-over-vinyl adhesive. If the old wallpaper is in good condition, it is recommended that vinyl-over-vinyl adhesive be used when installing the wallpaper.
How do I determine where I want the pattern to fall?
At the ceiling line hold an unrolled roll against the wall. On the back of the roll, mark the spot of where to begin. Upon cutting the first strip, leave a couple inches at the top and bottom for trimming. For a prepasted wallpaper, fill a tray 2/3 full with room temperature water. Roll the strip paste side out, bottom to top. Follow instructions on the roll, as they may vary.
Where is the best place to start hanging my border?
When hanging a border, you should start at the corner that is most unnoticeable.
What is the best way to hang border over wallpaper?
When installing border over wallpaper, a vinyl-over-vinyl adhesive should be used. Soaking the wallpaper is not necessary.
|
